1. Should not be filled with concrete hopper online, on-line super-size aggregate and debris to be cleared in time, when the mixing hopper card axis was never transferred, it is necessary to suspend the pump, and a timely reversal operation, troubleshooting, hopper of the concrete should not be too few to prevent air suction pipe and plug the cause, when the feed can not keep up, it is necessary to stop pumping in time.
、料斗网上不应堆满混凝土，对网上的超粒径骨料及杂物要及时清除，当料斗内的搅拌轴被卡死不转时，要暂停泵送，并及时反转操作，排除故障，料斗中的混凝土不能太少，以防止因吸空而导致管路堵塞，当供料跟不上时，要及时停止泵送。
2. And place the suction tip of the pipette into a special container receiving the dispensed liquid. The tip must be close to the inner wall of the container. Depress the pushing knob to the first stop and further more to discharge the solution completely from the tip. After that, you can take away the pipette
装上滴管尖，轻轻压下按钮直到首个停止位，将滴管尖以垂直方式置入溶液中，约在液面下2-3mm处，放开按钮使其慢慢回复原位并抽起的液体，再将管尖罝入容器的内壁，重新压下按钮排放液体，要压至首个停止位更下方的位罝，确保所有液体均被排出，压下排放滴管尖按钮，可将使用过的管尖移除。
3. In hot water heating system, in order to reduce the accident to stop pump water hammer, the pressure in the circulating pump suction tube is placed between the water and the pressure relief valve along the bypass pipe.
在热水供热系统中，为了减小事故停泵水锤，可以在循环水泵的压水管和吸水管之间设置一带止回阀的泄压旁通管。
4. The moment when a sudden stop pump, pump the water lateral pressure drastically reduced, while the suction side pressure is substantially increased under the action of this pressure, circulating water pump suction side piping of water that is open the valve to the pump outlet side of the pipeline system, thereby reducing the suction side increased the pressure pipe network in the magnitude; to reduce and prevent water hammer damage.
当突然停泵的瞬间，泵出水侧压力急剧降低，而吸水侧压力则大幅度增高，在此压差作用下，循环水泵吸水侧管路中的水即推开止回阀至泵出水侧的管网系统，从而降低了吸水侧管网中压力增高的幅度；减少和防止了水锤的危害。
5. suction stop
5. When the differential suction pressure reaches more than 1, 200, 000Pa (120mmH2O), the stand-by pump should be put in service and then stop the running pump.
当进口压差超过1，200，000 Pa (120mmH2O)时，应立即投入备用泵，然后再停工作泵。
6. suction stop的意思
6. Installing a strainer on the suction line inside a reservoir will stop the larger pieces of unwanted debris, such as nuts, bolts, cleaning rags and other miscellaneous items, from causing catastrophic problems downstream.
安装一个过滤器对吸力线内的油箱将停止较大件无用的碎片，如坚果，螺栓，清洁抹布和其他杂项收入，造成下游灾难性的问题。
7. Lift-type check valve structure improvement Lift Check valves, also known as the end, it can maintain the required suction pump to stop the water Globe Style Silent Check Valvescolumn; the valve structure is characterized by improvements in the main valve between the valve flap and valve stent slow addition of a Vice-valve closed.
升降式止回阀布局改进升降式止回阀又名底阀，它可以连结停泵时抽吸所需水柱；该阀布局改进的特点是在主阀阀瓣与阀体支架间增设一缓闭副阀。
8. Screw pump suction stop valve should be fully open the case of start, to prevent overload or suck air.
螺杆泵应在吸排停止阀全开的情况下起动，以防过载或吸空。
9. 公共查询·英语单词
9. Blinkers: The flaps on a bridle which stop a horse from seeing backwards or sideways. Influence of Non-nutritional Suction and Eye-shielding on Early-stage Gastro-intestinal Feeding among Critical Prematures
眼罩：附在笼头上的遮挡物，防止马向后或两侧观望。非营养性吸吮与眼罩遮光对危重早产儿早期胃肠喂养的影响
10. Pump stop, they would first close the discharge stop valve, and switch to a complete halt until pump suction stop valve was closed.
泵停车时，应先关闭排出停止阀，并待泵完全停转后关闭吸入停止阀。
11. suction stop的近义词
11. The finite element model contains the establishment of the model with variable section element and the disposal of the boundary conditions of the suction valve with point stop and the discharge valve with back plate.
本文采用变截面梁单元建立了吸气与排气舌簧阀的有限元模型并处理了具有点状升程限制器的吸气阀片和具有背板曲线升程限制器的排气阀片的边界条件。
12. The operation requires:(1) two elements folded edge suction nozzle position to relative accuracy; (2) two suction nozzle of air flow and absorbing and stopping to be consistent with air-time:(3) of this material, reply stop suction nozzle, aliquation-and-drop placard should just happens to be a book in a manner worthy of stationary set up in a manner worthy of the triangle.
其操作要求：(1)两个分帖吸嘴位置要相对准确；(2)两吸嘴的风量和吸、停气时间要一致：(3)分帖吸嘴停止吸气放帖时，应正好是书帖平稳地搭放在集帖三角架上的位置。
13. Therefore, five operational parameters such as mixed liquid suspended solid, flux, aeration rate, suction and stop time of the pump, and the ratio of up flow area to down flow area were chosen to undertake the orthogonal experiment in order to research optimum operational condition of the MBR.
为此，选择污泥浓度、膜通量、曝气量、抽吸/停抽时间、反应器升流区与降流区面积之比进行正交试验，开展了MBR操作条件的优化研究。
14. Lift-type check valve structure improvement Lift Check valves, also known as the end, it can maintain the required suction pump to stop the water Globe Style.
升降式止回阀结构改进升降式止回阀又名底阀，它可以保持停泵时抽吸所需水柱；该阀结构改进的特点是在主阀阀瓣与阀体支架间增设一缓闭副阀。
15. Lift-type check valve structure improvement Lift Check valves, also known as the end, it can maintain the required suction pump to stop the water Globe Style Silent Check Valves column; the valve structure is characterized by improvements in the main valve between the valve flap and valve stent slow addition of a Vice-valve closed.
升降式止回阀结构改进升降式止回阀又名底阀，它可以保持停泵时抽吸所需水柱；该阀结构改进的特点是在主阀阀瓣与阀体支架间增设一缓闭副阀。
16. Marine flanged cast iron single arrangement suction stop box valve
GB/T1854-1993船用法兰铸铁单排吸入截止阀箱
17. suction stop的翻译
17. Stop: Shut off the valve for the suction pipe.
停机：1、关闭吸入管阀门。